Toyota airbags and seat belt assemblies are recovered from specific vehicles, then inspected and tested at our Jacksonville shop before they are listed. Camry, Corolla, Highlander, Tacoma, and Tundra hardware comes through the most, so start with the Toyota listings. If you are keeping your original hardware, mail it in for a center airbag sensor assembly reset and seat belt repair.
Toyota and Lexus name the airbag computer the center airbag sensor assembly, sometimes called the airbag ECU. It is the heart of the supplemental restraint system. It reads the impact and occupant sensors, decides when to fire each airbag and pretensioner, and writes a permanent record of any deployment into its memory.
On many Toyotas it also ties into the occupant classification system that decides whether the front passenger airbag should arm. Once a crash record is stored, the assembly locks and the airbag light stays on, and a generic scanner cannot clear it. We reset your original Toyota center airbag sensor assembly in our shop, wipe the stored crash data and hard codes, and return it factory-ready. It keeps its original calibration, so it plugs straight back in and works the moment you reinstall it.

On most Toyotas the center airbag sensor assembly is mounted low and centered, under the center console on the floor tunnel between the front seats, secured with three bolts. On the Camry and Corolla you remove the center console trim to reach it, then unbolt the assembly from the floor.
Disconnect the battery and wait for the system to discharge before you touch any of the yellow SRS connectors. Then unbolt the sensor assembly and release its connectors, keeping it flat and square so it reads crash forces correctly when it goes back in. The location shifts a little across the Camry, Corolla, RAV4 and Tacoma. Call us if yours is hard to find.
Toyota uses B-series SRS codes. Deployment and crash-data codes clear with a reset. Squib and occupant-sensor codes can point to a part. Scan yours and look it up.
Every Toyota from 1996 and newer, we handle the center airbag sensor assembly and the seat belts. These are the common ones.
We reset your original Toyota center airbag sensor assembly and clear the stored crash data so the airbag light goes out. We also rebuild Toyota single, dual, and triple-stage seat belt pretensioners and free locked retractors. You keep your factory Toyota parts.
We run the same restoration work across every make. Here are a few more we handle every week.
Honda runs an SRS unit. Accord, Civic and CR-V.
Honda airbag service →Nissan uses a diagnosis sensor unit. Altima, Rogue and Sentra.
Nissan airbag service →Subaru uses an airbag control module. Outback and Forester.
Subaru airbag service →Ford runs the RCM. F-150, Explorer and Escape.
Ford airbag service →Pick your vehicle for its module location, common fault codes, and exactly what we restore. We handle every Toyota from 1996 on, so call if you do not see yours.
Mail us your original center airbag sensor assembly or seat belt. We clear the crash data, rebuild the pretensioner, and ship your factory part back ready to install.
Genuine OEM, tested, and shipped ground from Jacksonville, Arkansas.
Toyota parts and codes · Do not see it listed? Request a part or call 501-988-0611.