B0002 points to the driver's front airbag, second-stage deployment circuit. After an accident it is almost always the stored record of that airbag firing, which is data a module reset can clear.
Most front airbags fire in stages so the control module can match the force of the deployment to how hard the crash was. Stage 1 is the primary charge. Stage 2 is the second charge that adds force in a harder hit. B0002 is the code tied to the driver's frontal stage 2 circuit. When you read it, the module is flagging something about that second-stage deployment path.
After a collision where the driver airbag went off, B0002 is the module recording that the stage 2 charge was part of that event. The hardware did its job. What is left is a stored deployment record, the same crash data that keeps the SRS light on and locks the module so it will not arm a fresh airbag. That is why a parts-store scanner can see the light but cannot turn it off.
It depends on the car's history. If the driver airbag deployed, B0002 is stored crash data and our reset clears it. If the airbag never went off and the code appeared on its own, it leans toward a circuit or connector fault that has to be repaired first. The honest move is to read the full code set against the vehicle's history before calling it. Manufacturer wording shifts a little across GM, Ford, and Chrysler, while the stage 2 driver frontal meaning stays the same.
Yes, when B0002 is stored crash data from a deployment. Our airbag module reset clears the deployment record and hard codes and returns your original module to factory-ready condition, so the light stays off once it is reinstalled. If B0002 turns out to be a live circuit fault, the wiring or connector is the repair, and we will tell you that straight.
B0002 is a generic body code, so it shows up across GM, Ford, Chrysler, and most makes built in the last couple of decades. The driver frontal stage 2 meaning holds across all of them.
First, make sure the car is mechanically safe and the deployed driver airbag has been replaced with a proper one. A reset clears stored data; the physical repairs are a separate step that comes first. Then mail us your module. We clear the crash data and send it back ready to install. Related codes worth checking: B0001 (driver frontal stage 1), B0011 (passenger frontal stage 2), and B0053 (deployment commanded).
Mail us your original module. We restore it to factory-ready condition for a fraction of dealer cost, the same way we have since 1997.
Genuine OEM, tested, and shipped ground from Jacksonville, Arkansas.
Do not see it listed? Request a part or call 501-988-0611.