B0001 points to the driver's front airbag, first-stage deployment circuit. After an accident it is almost always the stored record of that airbag firing, which is data a module reset can clear.
Most front airbags use more than one inflation charge, called stages, so the control module can match how hard the airbag deploys to the severity of the crash. B0001 is the code for the driver's frontal stage 1 charge, the primary one that fires first. When you read this code, the module is telling you something happened with that deployment circuit.
After a collision where the driver airbag went off, B0001 is the module recording that the stage 1 charge was used. The hardware did its job. What is left behind is a stored deployment record, which is the same crash data that keeps your SRS light on and locks the module so it will not arm again. This is why a parts-store scanner can see the light but cannot turn it off.
This one depends on the car's history. If the driver airbag deployed, B0001 is stored crash data and our reset clears it. If the airbag never deployed and the code showed up on its own, it is more likely a circuit or connector fault that has to be repaired first. The honest move is to read the full code set and the vehicle's history together before calling it. Manufacturer wording varies a little across GM, Ford, and Chrysler, while the stage 1 driver frontal meaning stays consistent.
Yes, when B0001 is stored crash data from a deployment. Our airbag module reset clears the deployment record and hard codes and returns your original module to factory-ready condition, so the light stays off once it is reinstalled. If B0001 turns out to be a live circuit fault, the wiring or connector is the repair, and we will tell you that straight.
B0001 is a generic body code, so you will see it across GM, Ford, Chrysler, and most other makes built in the last couple of decades. The driver frontal stage 1 meaning holds across all of them.
First, make sure the car is mechanically safe and the deployed driver airbag has been replaced with a proper one. A reset clears stored data; the physical repairs are a separate step that comes first. Then mail us your module. We clear the crash data and send it back ready to install. Related codes worth checking: B0010 (passenger frontal), B0051 (deployment commanded), and B1193 (crash data locked).
Mail us your original module. We restore it to factory-ready condition for a fraction of dealer cost, the same way we have since 1997.
Genuine OEM, tested, and shipped ground from Jacksonville, Arkansas.
Do not see it listed? Request a part or call 501-988-0611.